Recent content by AHill

The lens stayed in place ok without the glue but I put a drop in each corner so there would be less chance of the lens shifting in the frame when installing or removing it. I don't know if the ca glue is right for the plastic lens, it may not be doing anything. If the lens pops out I'll reglue...

I would make several copies of the frames, maybe in different colors and put a different lens in each one. It would be very easy to swap them as needed. The spring clips on the bottom design make them easy to swap, pull out on the nose area to remove and push down on the top area, then push in...

I widened the top and bottom clips and I extended the top edge of the clip to the outside edge of the frame to make it stronger. It did make it strong enough to hold the lens without breaking. The lenses I had still would not stay on so it would also need the same thing done to the two side...

I started to modify your design by making the clips thicker and wider and then I found this design on Thingiverse. Lens holders for DJI Googles by obelix662000 I printed them in PLA, brought them to the dollar store and found reading glasses for a dollar with lenses that would match. The lens...

It does do screen shots by holding two fingers for one second on the side touch panel. I don't know about video. Also you can't use larger than a 32 gb card in the goggles.

I just got a clip on 3X magnifier from Harbor Freight, item number 66825 (about $6.00). It is meant to clip on over existing glasses. The clip in the center is easily removed leaving the connecting wire between the lenses. I slightly bent the connecting wire so the lenses would lay flat in the...

Thanks, I'll give that a try.

Mine are also at the widest spacing. Before getting the goggles I bought non-polarized no line bifocals with the dividing line optimized for looking down at the tablet and up at the drone, I won't be able to use them with the goggles. My reading glasses are blurry unless I pull my eyes a couple...

I ordered a Fly More Combo from B & H Photo on 11/10/2016 and received an email (with tracking number) that it was shipped on 1/3/2017, expected arrival date 1/6/2017.

Received my MavMount and I can verify it is a sturdy and well made piece of equipment. It holds my Nvidea Shield with Hoodivision sun cover as well or more firmly than the DJI tablet clamp. It is a bit easier to attach the tablet because it has a spring clamp, the DJI mount has to be pushed...

Go to thingiverse.com and enter Mavic for the search term. You will find the S clips for Nvidea Shield and quite a few other tablet mounts. They also have an option for them to print objects and ship the to you if you don't have a 3D printer.

Why are arms spread out in case? It seems to waste a lot of room and the case is larger than it needs to be. If the cutout was made for a folded Mavic it would leave more room for other items.