Recent content by AirJordan

I was thinking just now, I wonder if my picture profile actually has anything to do with it as I only just recently changed that. What profile do you use, D-Log or D- Cinelike?

What do you mean by intermittent artifact? Any suggestions for not getting it in post? And yes, when scaled to 1080p it was very minimal, almost intolerable to the naked eye. I would like to shoot in 4K but if it's more going to cost me a couple of hundred to get it fixed I might as well wait...

Yeah, 4K sizing. I'll run a few more tests but it seems like it's intermittent. If it's a problem I think i'll just continue to record video in 1080p because I don't really want to have to pay for repairs out of warranty.

I had a look at some vertical videos I took and some don't have it and some do.

New here guys, so where are some great, legal places to fly in ADL. Prefer good scenery. Seen lots on Instagram but it looks like a lot of cowboys who quickly fly illegally.

Does anyone else get vertical lines in their videos when shooting in 2.7K or higher? I don't think it's a sensor issue as 1080p videos and photos are fine. Here's an example (right pant leg) for consideration. Only noticed it recently as I rarely use my Mavic and usually shoot in 1080p. And DJI...

Received a DJI Mavic Pro and straight from the box, appeared to have a used screw on the rear leg, or may have even been a refurbished drone but, so far, customer service have been good and opened a case and TNT have picked up the DJI Mavic Pro for service on 11/1. My question is for the people...

You don't want my order from Rise Above?

I'm not sure if this is allowed here, but currently located in Adelaide and I got a hold of a DJI Mavic Pro. Just got a call from ModelFlight to say my order came in but I declined, so lucky next guy. I'm also currently in line with Rise Above which I might keep as I had a deal going with them...

I downgraded. Problem solved.

I would rather not risk it until I know that the problem has been fixed. Not knowing there was a problem in the first place freaked me out when I first tried to calibrate it.

Yeah, I read up on a couple of forums and ended up downgrading the firmware to 1.2.9 Problem solved.

Sounds and looks simple enough. I'll give it a go tonight. Thanks guys. What was the FW before 1.30

How hard was it to get it back to the older firmware, are there any instructions?

Did you give it a try? Did it work. I'm coming across the same problem.