Hello all,
I have flown my MM into the bushes and now getting the message: Gimbal stuck (code 40002). When I start the drone, the gimbal turns a few times and freezes. When the drone is off, I can turn the gimbal freely in all directions without any obstructions. I don't see any damages or cracks and the gimbal is hanging in the strings. I tried to calibrate the gimbal, but it stopped at 10%. I tried also a refresh of the software, installed the older software on it and installed the latest software again. This didn't helped either. Is there a way to fix this problem besides bringing it to a repair shop?
I have flown my MM into the bushes and now getting the message: Gimbal stuck (code 40002). When I start the drone, the gimbal turns a few times and freezes. When the drone is off, I can turn the gimbal freely in all directions without any obstructions. I don't see any damages or cracks and the gimbal is hanging in the strings. I tried to calibrate the gimbal, but it stopped at 10%. I tried also a refresh of the software, installed the older software on it and installed the latest software again. This didn't helped either. Is there a way to fix this problem besides bringing it to a repair shop?