I recently sent my Mav3 and controller in to DJI for repair. When I am looking forward through the camera and move the gimble wheel so as to begin looking down, for instance when the camera is level and I begin to view downward to, say, -40degrees and then remove my finger from the scrolling wheel, the gimble continues to drift downward. My FPV does no such thing. When I stop the scroll wheel movement the gimble stops the downward movement. I was sent a new Mav3 but the problem persists. It must either be the controller or maybe this is common? My friend with a Mav3 says it does not happen to him. Apparently they did not even test this? Or is this really common? In the attached video I am using the scrolling wheel until the gimble is looking down to about 40degrees then removing my finger. You can see the gimble movement slow down but continue downward. Is this normal or should I contact DJI again. I find it very frustrating to try to "back scroll" just the right amount to stop the downward motion of the gimble. Gimble Test Video