Get more from your Mavic
Friendly, Helpful, Knowledgeable Mavic Community
Join Us Now

M3 (New firmware) Pano's Fail

VenomXts

Well-Known Member
Premium Pilot
Joined
Apr 25, 2020
Messages
1,226
Reactions
1,796
Age
40
Location
Texas
Is anyone else seeing this, shot about 10 Pano's yesterday not too many issues other than a few didn't come out like I liked (was kinda windy and in upper 40's)

This morning was a bit more windy but nothing I don't shoot in normally with other drones and 39F and shot about 10 pano's... About 4 of them failed and just didn't finish, then it would bounce back to regular pic mode.... I was not that far away..

Anyone else seeing this with new firmware?
 

PHZ

Well-Known Member
Joined
Oct 15, 2018
Messages
235
Reactions
158
Age
72
Is anyone else seeing this, shot about 10 Pano's yesterday not too many issues other than a few didn't come out like I liked (was kinda windy and in upper 40's)

This morning was a bit more windy but nothing I don't shoot in normally with other drones and 39F and shot about 10 pano's... About 4 of them failed and just didn't finish, then it would bounce back to regular pic mode.... I was not that far away..

Anyone else seeing this with new firmware?
You mentioned it was more windy. If the drone moves too much, the panos will not stitch. Could that have been a factor?
 
  • Like
Reactions: dtp

VenomXts

Well-Known Member
Premium Pilot
Joined
Apr 25, 2020
Messages
1,226
Reactions
1,796
Age
40
Location
Texas
You mentioned it was more windy. If the drone moves too much, the panos will not stitch. Could that have been a factor?
the failure was not that they didn't stich, the drone stopped taking the pics about 40% through then crashed out to the main pic screen. It could of been wind just haven't seen this behavior on my air2.