Good Morning
I'm going around loads of houses trying to understand what I can and cannot here and any help of pointers would be lovely
I have MPP that had ver 1.4.0500 firmware, I looked at the optio to enable FCC mode via the Dumldore v3/jkson5 method and it states on the github page that it needs to be on ver1.4.0300 as a latest.
I downloaded DJI Assitant and it has enabled me to revert to .0300 and this is confirmed when I boot the drone up and in DJI Assistant. When I then go to use DumlDore the program boots up fine but when I go to enable ADB it says that the USB port is not valid/available...if I click continue it then says the port is busy ( I have made sure that there are no DJI Assistant processes still live ) - also in device manager there are no errors against the com port and it looks ok
Am I missing something critical or is there any info you chaps may have
I'm going around loads of houses trying to understand what I can and cannot here and any help of pointers would be lovely
I have MPP that had ver 1.4.0500 firmware, I looked at the optio to enable FCC mode via the Dumldore v3/jkson5 method and it states on the github page that it needs to be on ver1.4.0300 as a latest.
I downloaded DJI Assitant and it has enabled me to revert to .0300 and this is confirmed when I boot the drone up and in DJI Assistant. When I then go to use DumlDore the program boots up fine but when I go to enable ADB it says that the USB port is not valid/available...if I click continue it then says the port is busy ( I have made sure that there are no DJI Assistant processes still live ) - also in device manager there are no errors against the com port and it looks ok
Am I missing something critical or is there any info you chaps may have
