Hi, does someone have experience with similar problem, please?
Mini 2 controller can be powered on, but only once - works normally, control aircraft, firmware can be installed.
When turned off, it cannot be turned back on until both batteries are reconnected and USB-C charger is connected.
Then...
If someone is interested, here are photos of both sides of Mavic Air mainboard (this one is toast, propably overheated,
does not post, only yellow light) and close-up of damaged Mavic Pro 2 controller board.
If you want to replace your antenna, be sure to rip off connectors from antenna wire...
https://www.ebay.com/itm/CHIP-IC-BQ24259-ADMINISTRADOR-DE-ENERGIA-POWER-PARA-XIAOMI-REDMI-5A-MOTOROLA-E4/153444398447?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649
It is cheaper directly from China, but take several weeks to deliver.
On macro lens photo it look clear and easy -...
When battery connector is plugged in, nothing happen as there is shortage between
red and black battery wires - there is no shortage on other controller, therefore it is
a fault. Smart battery detect this shortage, otherwise we will see, hear and smell it.
All batteries are fully charged in...
There is single IC connected to battery red wire, therefore short to ground should be in this IC (or that resistor/capacitor between, but IC is more propable cause) :
Looks like I found the problem - battery connector is propably shorted.
There is conductivity between red and black wires and these silver pads near battery connectors - are these battery voltage
measure points ? These are connected together too.
Same wires on Mavic Air controller battery...
Battery connector on PCB is not damaged (at least not visible damage).
Yes, using bottom USB port to connect phone works - battery controller shows
1% with any battery and with battery disconnected from PCB.
When powered from side USB, controllers is fully functional - except controller
is not...
There is only one discussion found by Google:
https://forum.dji.com/thread-205152-1-1.html
Moderator on this forum recommended firmware update, when it clear that LCD screen is cracked.
There are 0 results to LCD type on Google.
Hi, does anyone have experience with replacing cracked LCD screens inside ?
DJI Goggles (not racing edition, big white one) have both LCDs cracked after a drop. Looks like standard
industrials LCD panels, but where to get replacement ?
Screen 1
TT497-79-CS6P2-E 170713 S
TFT3P5560-V1-E...
Hi, does anyone have experience with following problem, please ?
GL200A controller is not charging any battery, show "CHARGING", but stay at 1% and it cannot
be powered from battery.
- same battery work in Mavic Air controller and can be charged
- none of the batteries is discharged (fully...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.