Recent content by 400ftview

I thought I had this problem but it turned out my Allen driver was stripped. A closely-sized Torx driver bit into them and saved the day until I could get a new 1.5mm Allen driver. Worth a try.

For anyone else who's struggling, I found this tip from erbanassault on YouTube; worked like a charm: "You need two pair of pliers, one to hold the top cap where the two screw holes are open. A second pair of pliers holds the silver Square Spring holder. Twist the two parts to halfway and...

@Thunderdrones I had a crash that ripped the gimbal off my mavic. I replaced the ribbon cable, silver cable, and vibration board which were all severed in the crash. The main control board, camera, and motor assembly all looked in good condition. Now I'm getting a gimbal overload error. Did...

Thanks for the description, @Thunderdrones - it was very helpful. I'm replacing both pins on a crashed Mavic - they were sheared off. I got what looks like two identical replacement pins from Amazon. When following your description, one of them pops in beautifully. The other - well, not so...