When I got myself the Mini 3 Pro I got a friend to print me this case for it. Now that I've got my eyes on upgrading to the Mini 4 Pro I wonder if it'll fit in the same case?
To anyone with both drones is this case compatible with both drones...
I may consider that. The problem is limited realestate in the camera bag. I can just fit the drone in its 3d printed case along with the remote into one of my compartments.
Not being sarcastic, but do you have anything aside from pavement where you're from? Easy to lose tiny things when you're out and about rocks, moss, fallen leaves, etc.
Since the stock sticks are so tiny, easy to drop, and NON magnetic I would really like some replacement sticks that would stick to a magnet if I were to drop them. Can anyone recommend a 3rd party stick that would meet this criteria?
I actually modded my controller of the Mini 2 to achieve this without opening it. These pictures show where the beeper is situated. Simply set the depth of your drill bit at 2mm, just enough to make it through the case of the controller, then thread in a small screw. You can use this to apply...
With any luck it will come to pass, but as someone who checks the forums daily I have seen many promises from DJI simply not come to pass, or take forever.
I'm with you though. The release of the SDK would allow many programmers to release the full potential of this drone!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.