Recent content by FastHampster

ok, just to make sure i understand. If i go up a hill for example and that hill elevation is 50 ft higher then the starting point and the trees are additional 20 feet totaling 70 feet. If the RTH is set for 50 feet it sounds like it will fly directly into the trees then. Is this correct?

ok so i should have asked this in the orginal post. If RTH will climb to zero then add the 50 feet. What happens when you go up the hill and the evaluation is now higher then the take off point. Will it add 50 on top of the current height or would it subtract it off? Thanks for the replies.

Hi Everyone, my question is if are say in a middle of a hill at launch and you fly down hill i see the evaluatin setting starting to go in the negative. How can you tell what is the correct height from the ground. If the air craft was to be in RTH mode would it go from height at take off plus...

Here is an image i got from the Internet. My video cable the small fine wires was pinched under the forward sensor. I did buy a video cable as you can replace it. I believed it was the cable as it would come and go and wasn't always consent. I would have to think if it was a chip the issue...

how are you making out Chipz? I could replicate my issue by tapping on the front of the nose of the mavic. My phone would show a clean image and once i tapped the top of the front the purple lines would come and go out. If i tapped multiple times the lines would be intense and the camera...

I just got this as well. I updated the firmware on both mavic and remote and the battery is now working. Here is a picture of cells. Waiting to see if i charge it to 100 if it will work or not.

Bak, is trolling hard, Sir, we sincerely apologize for the inconvenience. Upon checking the case log, the management has tried to dial the number for 7 times in a row with no success. A new case has been created, please kindly arrange to send the unit at your earliest convenience, the...

MavicMT is trolling.." No way to treat a new customer" lol

Hi Dyno, i just recieved a cable and started to dissemble the mavic. When i got the cover off i noticed that the video cable was pinched under the left side forward sensor. I re/re the sensor and removed part of the wire that was pinched. Reassembled and the video is working now with no...

Hi Rob, Just wanted to let you know i took the drone apart and found that video cable, was pinched under the forward sensor left side (drone facing you). put it back together and haven't had pink lines or interruption of video since. I did about 20 mins of video so far. Have to see if it...

Hello Everyone, from outside of the GTA in Ontario Canada. Thanks for the site picked up a used Mavic pro and will be doing an operation hopefully by the weekend. Great site with a ton of knowledgeable users.

Thanks i have message Thunderdrones to see what their thoughts are and if they sell the cable.

Thanks Jason, i am in Canada as well just outside of Toronto. I am going to order the grey cable from amazon and try it out and start there. Mine has the purple pink lines directly on the controller as well and in the cache form the flight. The funny thing if you start it up the video is...

Hi Dyno, did you fix your problem. i bought a used unit as well and it seems it has the same video issues regarding the pink / purple at times and other times no issues.

Hi Everyone, I purchased a used Mavic Pro knowing it had this issue please see the video. If the video doesn't post the video and images of the Mavic Pro have a purple / pink colour. This can happen all the time though there are times when the video or photo can be crystal clear. I take...