Recent content by JimNorth55

Just an update... After some back-and-forth with "DJI Wanda" on the DJI site (which was not helpful), I decided to ship the drone off to Drone Nerds Repair Service, which I have used in the past. I included a detailed description of the problem, including a step-by-step procedure for how to...

Thank you for conducting the experiment and reporting back. Now I know that I am not expecting a feature that is not supposed to be there, and that the controller hardware is not the cause. I will try your suggestion, and if it doesn't fix the issue, I'll keep at it. Eventually I'll figure...

Normally, my settings are: Max Tilt : 10 and Smoothness 30. However, so we are comparing apples to apples, can I ask you to try something... Set your your Max Tilt to 30 and your Tilt Smoothness to 0. Then try slightly moving the gimbal tilt wheel and see if you can gradually increase...

I don't see any EXP (or Expo) for the Gimbal, only Max Control Speed (Tilt) and Smoothness. Just above there is Expo for Pitch/Roll, Yaw and Up/Down, which are the sticks. And, as I mentioned before the Max Control Speed does control how fast the gimbal tilts, but that doesn't matter. As I...

I performed the RC calibration, as suggested (after updating the Fly app), and still have no proportional tilt speed control with the wheel. The gimbal tilt wheel acts more like an on-off tilt switch, than a proportional speed control.

Updated the Fly App. RC and Aircraft firmware is up to date. Still no proportional tilt speed control.

I was flying my Air 2S with the RC Pro today, and I noticed that the gimbal wheel has no proportional control over the gimbal tilt speed. With my Mavic 2 Pro (using the stock controller and the Go 4 app), when I rotate the wheel a little, the gimbal tilts slowly, and when I rotate the wheel a...

For what it is worth, here is my experience with (not) removing the stock filter from my new Mavic 2 Zoom. I watched one of the YouTube videos out there, which suggested wearing "rubber" gloves, but was only able to get it to turn only a degree or so, using an uncomfortable amount of force...