Recent content by Lzet

This is very true. I learned, when the drone is more far from you, the signal strength depends on the side the drone is turned towards the RC. The strongest signal you get is when it faces toward the RC with its front arms (the camera is looking at you). So the flight is safer on its way home...

For others who want to fly drones in Czech republic here is a link to Drone flight planning web application in English

Were you aware, that is an Restricted aerial photography area? Did you have any trouble with locals? I am going to spend one week on Lanzarote, but watching their Drone aerial photography restrictions, one can drive the drone inside the transport case.

I would a bit disagree, with the above statement. There is a huge difference flying without sensors and flying without stabilizators like GPS. This is what you experienced with the original cheap drone. At the moment you need to do a lot of maneuvering just to keep your drone hovering on the...

No clue what kind of drone do you own, but for dji drones the controller sticks calibration helps, neither compass or IMU controls your flight direction (apart of RTH) but your controller sticks ;) at the moment they are not balanced specially at the default middle position you can encounter...

wifi of the mobile/ tablet operates on the same frequency range 2,4 and 5,8 GHz as MA2 does, they could interfere, so I better switch off the wifi

For my mavic air 2 I have designed and printed out a simple mount extension.

I am a bit curious regarding electromagnetic interference with antenna as the galaxy TAB S6 cover back side is full of permanent magnets for keyboard and pen adhesion and not sure how does it influence the fligth range. Any experience?

I own a 3D printer (printing the holder for OSMO Pocket) so I designed and printed it out. Same way I have printed a mobile phone holder for OSMO Pocket which you can hold in hand or mount on tripod. Weight is 42 gramms. Easy, isn't it ? ;)

As I am an older guy I need a big scren. Happily using for my P3P and MA a Samsung Galaxy S2 8 inch.For MA I have a 'home printed' holder to fix the Tablet with Mavic controller. Both DJI GO and DJi GO4 working well screen resolution 2048 x 1536.

Hm Cheb je malinko z ruky. A co by to konkrétně mělo být?

I got this warning yesterday during some strange ´dancing´ excersize Mavic did when only hovering - so no maximum flying speed at all. I suspect, it could have a relation to tired propeller (s) and that motor needed to speed up to it´s maximum limit in order to get the drone stabilised. I am...

Why to make it so complex? I took sketchup and printed a very very simple holder o´fo OSMO pocket joint with Sammsung A5 2016. No screws, just connect and move it in the holes. Light weight and portable. Makes solid connection, all buttons reachable. btw. Samsung has Micro USB so there is a...

Simple OSMO pocket extender for those who need an additional USB-C/micro USB adapter for Samsung 3D printed costing few bucks :D

Mine advice would be : 1. Get used to control you brand new drone at the solid ground 2. Try to find any kind of landing gear extension - even the small MA propellers are rather sharp when they hit your fingers 3. Only one moving subject at the same time MA or the boat either or both moving...