Bought two sensor on aliexpress and replaced.
Once the drone was turned on, the drone magically started working again and does not display the error message. Case closed!!!
Sensor calibration is only available for optical sensors and not for IR sensors. Yes, they have been cleaned well from both the outside and the inside. The drone got damp, I found several signs of damp on the CORE board but it has no obvious damage. I also found signs of wet oxide on the two...
Sorry, I thought putting a post in the mavic 2 Pro section was enough to describe the drone. Sending the drone in for assistance I see it as a bit expensive operation given their costs. I was thinking of buying the two cams and replacing them myself. thanks for your quick reply.
Friend, I have same problem. After replace motors and cable s i have only video but not moving. App no error codes, but I have only serial number of camera but of gimbal i have n/a
After a crash I changed the gimbal cables and motors but now the motors do not move, no errors in the dji go app, images and zoom working, the drone arm but the gimbal motors do not work. In the dji go app the gimbal menu does not appear and the serial of this is not there but it is written N / A
i have my gimbal in repair after a crash. If I turn on the Mavic 2 Zoom without the gimbal I get the error code 200 and the SD card in the slot is not detected. If I connect the Mavic 2 with USB cable to the notebook I see the contents of both the internal 8gb and the contents of the SD card on...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.