Recent content by malepilot

I have many incidents of video link cut off after interference (as seen in the link below). And the only way to get it back is to land the Mavic and restart everything i.e. the Mavic, the RC and the DJI Go 4. This happened after I upgraded to 0.600 and persist with 0.700. .700 is here...

Did you get any interference before you lost the video feed as in the below : .700 is here "The-f-word" There is new firmware once again!

@flyNfrank When you revert back to .0400, is there a need to downgrade every battery ? Thanks

Thanks for sharing! Feeling relief hearing this, as no one else in this thread has posted similar issues before.

Similar interference as in my video ? I shall revert back to 0.400 tomorrow. Thanks for sharing.

I have seen many drone videos on YOuTube of flying over Sydney Harbour Bridge, Opera House and ANZAC Bridge, all are within the same Restricted Zone of Sydney Harbour. Just too many idiots go against the law and think they are so smart with good skills that can do anything they like. At the...

Anyone experiencing video downlink interference after upgraded to 0.600 or 0.700 at the same location prior to upgrade ? After I upgraded to 0.600 and then 0.700, my Mavic became more sensitive (prone) to interference at same location which had no sign of interference before. Right after the...

Haha ... Thank you

What is OAS ?

I have contacted DJI support and here is what they suggest : 1. factory reset via the DJI Assistant 2. 2. firmware refresh via DJI Assistant 2. 3. Manual relinking of aircraft and remote controller. 4. IMU calibration. 5. Gimbal calibration. 6. Compass calibration. It is night now in...

Hi there, Any progress with your black screen issues ? I have the same problem started few days ago in the areas that I used to fly without any issues. I have been trying to find a solution but still can't resolve it. I have tried on both iOS and Android and the screen blackout on both...