I had a similar issue on my Mini 3 Pro. My controller showed a momentary state of weak signal before the drone appeared to pitch left. The logs did not provide a definitive cause other than a possible bird strike since there were no aerial objects in the area. I will be following this post...
Also shows deceleration down to 1.9mph with no change is stick movement between 5m 45.3s to 5m 47.3s. I believe this is what @slup was referring to. I wish I had the ability to overlay the log onto the video to Id the exact moment match to the log.
Thank you for the clarification. So could this be caused by a malfunction or solely external forces? Both?
On Airdata, you can see there is a deceleration from 21.9mph@5m 36.9s (right stick full left) to 2.0mph@5m 39.3s (right stick full right). Could going from 22mph to 2mph in a span of...
I have had slight gimbal movement on really windy days but not as extreme. As another commenter pointed out it was possibly due to my input going from full right to full left and the drone shifted to an extreme angle outside of what the gimbal can adjust for. If I recall correctly the signal...
It appears that this message could display if the propellers are not unfolded properly, which could have been the case. Of the 80 logs on the controller only a handful gave the error "Check whether the propellers are attached to the correct motors based on their markings. Incorrect installation...
I checked the propeller placement and they are in the correct spots. I'm going to check past logs to see if I get the same messages. I'll let you know what I find out. Thanks for your help.
That’s interesting that the gimbal did not adjust to keep the image level during braking event. Could a bird strike cause this?
Thanks for the pro tip re: flight reader
how about now?
https://drive.google.com/file/d/1n7gSfra3VY0kFGc2ZhKo1vPg-7bW23mO/view?usp=drive_link
Log attached - missing 10 seconds starting at 5m 35.3s where the gimbal twitched.
https://www.phantomhelp.com/logviewer/4CXVC118AJMCBRLYWGAQ/
I had an issue with my gimbal during low signal strength to my controller @ about 2300 FT out. I upload the logs to phantom help and there is 10 seconds missing during the time of the glitch
I did see and respond to a post of a similar issue, but it was Mini 2 that was landing. My initial...
I had the same issue when I had low signal strength to my controller @ about 2300 FT out. I upload the logs to phantom help and there is about 10 seconds missing (see link below).
I was going to start a separate post but this thread showed up when I types the new title. Anyway, my initial...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.