Recent content by phildebougi

In fact after an examination with a magnifier, what I thought to be a cut a cutted wire is in fact a piece of plastic (see first image above). Thank you.

It seems that the front leg antenna is still wired as can ba seen on the picture below; dont you think so?

The left front landing gear of my Mavic has been broken during its transportation. In order to fix it with an epoxy glue I have unscrewed the gear from the front left arm. After I had separated the gear from the arm I noticed that a small string - made of black plastic - was cutted (probably I...

How shall we be informed that DJI has issued a DJIGO app that corrects this issue and that we can re-update our smartphone/tablet without a risk to experience again the scrambled video problem?

I have just downgraded to v42.12apk. Completed a 10 minutes fly with no problem of scrambled video. I am crossing my fingers hoping it will continue. As of the Arnold 's link it seems that DJI is working to solve this issue.

When the Mavic is on the ground the video on the RC screen (Android device) is perfect. As soon as the drone has taken off the video becomes extremely scrambled. I have done everything I can to correct this problem without any success : · Multiple re-install of the Dji Go 4 application...

-> Hi, msinger; Thank you for taking care of my problem what is the extension of the relevant message? is there any date associated to the message?

I took off in my garden from the exact place where I had used lot of times before. Attached is the file that I suppose is the flight record. I also have a .dat file in the McDatFlights directory which is not permitted to upload. Thank you for your comments.

For the third time in 1 year since I am flying my Mavic Pro, a few seconds after I had taken it off, as it was about 2 meters above ground, it rapidly started to fly out of my control. Finally it hit a wall of my house and felt down on the ground. This incident occured after I had uploaded the...

OK I have found the About section in the Settings. It displays: Aicraft -> Check for Updates Remote Controller-> 01.04.300 Is it the right place to update RC and MP?

-> lisadoc + wartycauldron I cannot see which command of the Settings enable updating the MP and the RC. Thank you for your help

Thank you, I have re-posted the subject under Mavic section

In order to update the firmware of my Mavic Pro drone and its Remote Controller, I have downloaded the last issue of the DJI assistant (DJI Assistant 2 1.2.4) and I have updated the drone without any problem. I am now trying to update the RC firmware but after launching the DJI assitant 2 and...

I have now succeeded to restart the RC after I have reset it (by pushing simultneously the C1+C2+Record buttons). The RC screen says "Connecting". I connect the RC to an USB port of my PC and launch the DJI Assistant 2 software. DJI Assistant2 displays the same screen than abov and nothing else.

The problem is even worst than yesterday in this respect that I had recharged the RC and now when I push the ON/OF button the screen displays "BAT 100 PCT" and nothing else even when pushing this button for 1 minute. Is there a method to reset the RC?