I have a new arm on order and will use the existing motor etc. Here are some photos.... The epoxy on left arm is just to offset the balance of rgt side
Has anyone replaced an arm on a Mavic 2 Pro??
I was flying on a very cold night and battery drained very fast and during auto-land I flew into my roof. Break is around the end motor housing. I have used JB Weld to repair it and it flies great but I still would like to replace it. Looks like...
I would be very careful with that (as I am sure you were) ... Messing with the props can alter a lot of things. How did you make sure the weights were uniform etc???
Yes. DJI treats you very well if you have refresh. I am on Mini #6, Mavic 2 Pro #2 and Mini 3 Pro #2. Most of my issues were defects in either hardware or software. One of the Mini's is at the bottom of a lake. DJI had me send the telemetry and they saw that the software had an issue and...
Weather was bad but I did get a few shots from my Nikon. There was no shadow with this eclipse! It never got dark like it did with the last one. We drove just south of Chemult OR where the path was centered. right after I got setup and started to put my Mavic 2 Pro together, my wife says here...
Tomorrow is the big day but the forecast throughout Oregon does not look good for viewing. We shall see.... I plan on going up pretty high and doing a time lapse of the ground to see if I might catch the shadow moving through. Worth a try I figure..... 30 minutes of fun I hope!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.