Recent content by Roger D

I would guess that means I'll have a new serial number and have to re-register it?

thanks, I started the process and will be sending it in tomorrow. thanks again

Thanks, I was wondering if perhaps camera settings changed and reduced pixels or something?

crashed drone hit retrn home and raised up into trees. One side of upper body was slightly separated, popped it back in. A rear cylinder in back of camera was loose and popped that back in. Forward sensor didn't function recalibrated. The drone flys, seems gutless compared to before and picture...

Yea, I hit go home and as it was starting to land I took it back up without the sensors activated and ran into a tree. Not fast, but it did bounce around in the limbs (evergreen) on the way down. I bought the replacement plan because I knew as a newbie I would crash...Just didn't want to use it...

went back and tried it again. I think I was misreading the pics and was waiting too long... The imu successfully recalibrated thanks

none

yes I ht a tree earlier today and it seemed to fly ok. and I was prompted to update firmware between the two attempts at imu calibration

I have restarted it two or three times and tried those instructions and it does not get past the first two dots or being in the normal take off position/flat on the surface feet down. After a while I just repositioned it anyway, nose down and then nose up and then it prompted me to put it on...

I am trying to calibrate my IMU and I have rebooted it two times. I have used half a battery and it has not prompted me to change positions yet. Is this normal. How long should it take to calibrate? Thanks