Recent content by SirMichael

I did manage to get the drone to work! I started looking around and found an "Unlock Request" so I started into that, which required me to log in (though I had already logged in when I first opened the GO 4 app). I didn't finish the "Unlock Request" though... I also managed to get the Stick...

Working on a Mavic Pro (circa 2018) for my brother-in-law. All batteries were shot so I bought 2 new drone batteries and one for the controller, got that changed OK. I also bought a ROKU RF ID for it, but not installed yet. I have the drone connected (OK) to an Android phone (used my DJI...

Thanks for the replies everyone. I did order a pair of new batteries for the drone & a replacement battery for the controller (I can change that), as well as an RF ID. I tried a few tricks with the old batteries (hibernation) but that didn't work. As suggested, we'll probably hang onto the...

My brother-in-law was given a Mavic Pro (circa 2016 I believe) from his son, who (as I understand it, got it from a friend). Three (bad) batteries, case, drone & camera cover, plus a plethora of cables & battery charger. So, since I have a Mini 4P, he asked me to take a look at it. Looks...

Bill, You might want to write up a small article and submit it to QST Magazine, perhaps in their “Hints and Kinks” section. It is very clever and simple to use! I have a Mini 4Pro and I may play around with that concept, I think it would work very well. I can see making a small wire frame...

So, with the latest firmware update on the RC 2 controller screen controller, there is a “Skate Park” simulator for the drone. I’ve been using the motion controller with my goggles Integra, which is very intuitive to fly, but I wanted to learn more about using the stick controllers on the RC 2...

I just downloaded the latest version of firmware for my RC 2 (with display) and there is a built in simulator which is nice. One thing that i noticed is that there is a Flight Path Vector (cross hairs) to show the flight path. I have this on my Goggles Integra (& RC Motion 2) which is very...

Yes, I have an RC Motion 2 controller. I was hoping to find an inexpensive mini drone that I could use. The ones that I could find on the site that you suggested were about 500 to $600. Sir Michael

I have the Goggles Integra & RC2 for a Mini Pro4. Are there any other drones that I can use this combination for FPV such as a less expensive (mini?) drone. Are these goggles & controller compatible with any other drones, other than the DJI variety? Sir Michael.

You can actually measure it. They make some inexpensive devices to measure the battery capacity in MAH (milliamp hour). You would need something of a load resistor for the battery.. check Amazon and EBay. Mike

I have some short velcro straps and I just cut off some pieces about an inch long, one for each end. It's not a real good solid connection, but it did help.

I've got the Goggles Integra and there is a head strap that goes over the top. However, the velcro doesn't hold very well. Is anyone aware of a replacement for the strap with some stronger velcro that won't let loose so easily? Sir Michael

Thanks everyone, it may work OK. I'll just have to see if I want to try it. Sir Michael

I have a Mini 4 Pro, the RC 2 controller (with display) and the Goggles Integra & Motion controller. I'd like to purchase a spare Mini 4 Pro and use it with my existing RC 2 & Goggles. Is there any problem with the setup? Can the controllers be mated with 2 drones? Will the...

Looks like it won’t work. In the table above, I do know that the motion controller 2 to works with the mini 4 Pro, but the table could be talking about the motion controller 1. Thanks for the help guys! Sir Michael