Recent content by bcwoodcarver

Hi just tried with controller only. Same result intermittent connection

Lose image transmission but can control drone for a few seconds. Tried calibrate drone but it stalls at step 2/5. Shows mag interference with no metal near drone or controller. Thanks for any help.

Hi I have connected the zooms controller and it will power up but it switches from aircraft connected to disconnected and flashes mag interference when no magnet or metal is close. Not in beginner mode.

Tried zoom controller but the pro 2 range height etc was restricted. Thanks for the help

My controller for my2022 pro2 has a screwed USB port and will not charge. I have a second controller from a mavic zoom 2020 that dies charge. I tried use the zoom controller with the pro2 with no success. Can the zoom controller be paired with the pro2 drone? Od do I need to send the...

OK thanks. My brain needs a challenge , learning new stuff.

Tried many.

Problem is not the cable . It is the port on the controller

I'm in Canada so makes it difficult.

Yes

The charging port on my controller will not accept the charge cord so I can't recharge it. Any help?

ok thanks

will do . None available at dji. Is it type c to micro-b 2.0 ?

nothing, it worked fine two weeks ago. I did buy a drop device that worked and is now disconnected.

dji go 4, connected rc with the supplied connector. Connect rc to phone , enter dji go4 . hit connect to device, do step 1 and step 2 at step 3 it will not link with aircraft.