Hi All!
Like an absolute idiot, I took my drone off the last week with one of the arms still folder in. It went up, hovered for a bit at about 4 metres and came crashing down (wont be doing that again).
The damage didn't initially seem too bad, and from the looks of it only required a top shell replacement, as the lens to the upward sensor had smashed.
Turning it on today, it is doing something a bit weird:
- Battery goes in.
- Double tap power on button.
- All 4 motors do their initial turn procedure.
- Then nothing, no sound or fan start up.
- Controller doesn't connect to drone either.
I've tried plugging the drone into my PC to see if DJI Assistant can reveal anything, unfortunately the drone doesn't connect. I have tried the different install techniques, disabling firewalls etc. I think the drone just isn't powering on properly. Furthermore, I've had a look at the soldered connections with the top shell removed, but nothing looks too amiss.
If anyone can offer any insight on what I can check, I wanted to avoid sending it off for an expensive repair etc however its looking like something is wrong a bit deeper than I thought.
Video link below and photos attached.
Video Of Motor Startup
Thank you!
Like an absolute idiot, I took my drone off the last week with one of the arms still folder in. It went up, hovered for a bit at about 4 metres and came crashing down (wont be doing that again).
The damage didn't initially seem too bad, and from the looks of it only required a top shell replacement, as the lens to the upward sensor had smashed.
Turning it on today, it is doing something a bit weird:
- Battery goes in.
- Double tap power on button.
- All 4 motors do their initial turn procedure.
- Then nothing, no sound or fan start up.
- Controller doesn't connect to drone either.
I've tried plugging the drone into my PC to see if DJI Assistant can reveal anything, unfortunately the drone doesn't connect. I have tried the different install techniques, disabling firewalls etc. I think the drone just isn't powering on properly. Furthermore, I've had a look at the soldered connections with the top shell removed, but nothing looks too amiss.
If anyone can offer any insight on what I can check, I wanted to avoid sending it off for an expensive repair etc however its looking like something is wrong a bit deeper than I thought.
Video link below and photos attached.
Video Of Motor Startup
Thank you!