Recent content by jjmucker

Agreed. This thread is getting a little lost here.

I'm a professional photographer but this doesn't matter. Professional or not, when the heavy noise reduction kicks in anyone can see it. The heavy noise reduction problem is horrendous. When you do the reset and get clean footage I'm more than happy with the footage from this quadcopter, and...

After the new firmware updates? Did you have the watercolour effect all the time prior to this?

Not sure ,but as I said, most were surprised by the Phantom 4 pro so close to just releasing the Phantom 4.

I would say 6 months isn't early days going by the Phantom 4 to Phantom 4 pro upgrade Sent from my iPhone using MavicPilots

I don't think they will 'fix' this Sent from my iPhone using MavicPilots

No you'll more than likely have to do it everytime you boot up the drone. Sent from my iPhone using MavicPilots

Do you have to do all these 3 things every time you boot up the quadcopter? Sent from my iPhone using MavicPilots

That sounds spot on. Sent from my iPhone using MavicPilots

I think so ( hope so ) Why would you think it wont?

Did they actually delete that thread. That's poor man.

I think PAL and NTSC are the same , in the sense of image quality. The reason you got better results with PAL is because you switched ( either way ) and that solves the NR problem until a time as which we don't really know. Most likely a reset.

Seems to be mate. I'll be leaving mine at 0 0 0 as its more than acceptable and i'll always do a pal - ntsc - pal reset on every flight

Did a few tests today. ( again ) I let the camera record whilst doing this, 4K, 24fps PAL. Had it on D-Log, 0-0-0 all round. Footage looked great, went into and changed it to -1 sharpen, and the very moment i did that, NR kicked in and went horrible, and not horrible as in, oh its taken the...

****. Ive never seen it do that before. Actually get sharp in real time like that and go back to mush