Recent content by Pl8er

I'll give this a go. Not sure if you saw my other posts, but I have attempted this upgrade so SO many times. The log shows over 50 failures.

Of the dozens of methods I have tried, I don't think I've gone down this path. When you say turn off the wifi, do you mean completely? Just wifi off? Do you upgrade in RC or WiFi mode on the bird?

On my way back to 1.3.00 i can no longer use wifi to connect

I was able to find the log. I was referring to the one that tells me why it fails over and over. At this point, I have no choice but to stay with 1.3.0. It simply will not upload. I counted the fails in the log, and it is 52. I've tried to update over 50 times, using multiple machines...

I really do appreciate the assistance. Through this at least I know how to downgrade and make certain everything matches. So there is that :) But there is some sort of wall that blocks me from going above 1.3.00, 1.3.4 doesn't work nor does 1.3.2 very frustrating.

How do I extract that log? I'm stuck at 69%, which means I am going to fail soon. I'd like to see what it says.

Really appreciate the help here. So far, no go - but I'm pulling out all stops. I plugged in each device individually to a pc (assistant 2) next I downgraded and refreshed to 1.3.000 Then a new battery, and onto an Ipad Pro - reinstalled that app, connected the RC to the IPAD and connected...

Just failed twice that way too. It now goes to 69%...stays for a few and next goes directly to 90% and fails.

Swapped out both cables (short for RC and new for Mavic) trying now Thanks!

On update attempt 26 (i'm serious) fails at 90% on the app and 55% on the assistant 2

I still am unable to update. I cannot get 01.03.02 or 01.03.04. They both freeze at 55%, I've formatted the SD cards to fat32, I've tried a different SD card, I've refreshed 01.03.00. I'm running out of ideas.

On attempt 9 now, still failing. back to the app, trying to follow some information I saw on youtube. I reset the initial firmware before trying to upgrade. fingers crossed

I unfortunately am stuck in the same loop I've been in since getting the Mavic. I have never had a firmware take. The RC will, but the mavic just fails each and every time. I had restored factory defaults, I've tried with the app, I'm now using the assistant. Literally just failed again...

I've reset all of the camera settings and went back to only adjusting the style to -1, -1, 0 I'll give that a go tomorrow.

Thanks for such a FAST reply! I do have filters in the mail, and perhaps that is all it comes down to (which would be terrific). I just want to make certain I don't have something running in the settings that I shouldn't.