Recent content by Streamside

Thanks for the replies. I have the advanced gimbal settings I shared in my original post programmed into the Normal mode so I don't actually have any need for the Cinema mode. This morning I flew the drone and it behaved much better, so I think the issue may have been from lack of calibrating...

I recently purchased a reconditioned Air 2S on Amazon and have unfortunately noticed that I cannot finely control the forward movement of the craft. On my Air 2 I could move forward at a snails pace if I wanted to, but with this Air 2S the minimum speed forward is at least 10 mph. Once I am...

Ah, interesting. I wonder why my iPhone freezes up when using Go4. Time to contact DJI for some tech support. Thanks for your input.

I have an iPhone 11 Max Pro that I have been trying to use with my Mavic Pro but the touchscreen will not work. Then yesterday I looked at the supported devices for Go4 and the iPhone 11 is not listed. Really, no love from DJI for the new iPhone? I have installed Litchi and am learning how to...

I think the problem might be that the iPhone 11 is not compatible with DJI GO4. My phone is not on their list of supported devices. Ouch.

THE PROBLEM IS BACK! The iPhone touchscreen while in DJI Go4 will not work, whether I am using the bottom USB port or the side port on the controller... Yikes.

Thank you Mike, it looks like the side port was the problem, and using the bottom USB port solved the touchscreen issue. Many thanks again for all who responded to my question!

Thanks very much for the replies. I tried your suggestions of replacing the cable and uninstalling / reinstalling DJI Go 4, but the problem is still there...

I recently bought an iPhone 11 Max Pro and have discovered that when the phone is connected to the Mavic Pro controller the touchscreen will not respond. I am using the latest version of DJI Go 4 and have downloaded the most recent firmware. When the controller is not connected the touchscreen...

I recently recieved a replacement Mavic Pro via the Care Refresh Program. I have noticed that when I shoot at 4K/23.98 frames and 1/50 second, with custom settings of -1, -1, +1 and D-Cinelike, that the middle of the frame is sharp but objects on the left half of the frame are quite blotchy...