Ok. So… as a proof of concept, before I started soldering and unsoldering leads on my drones ESC, I DELIBERATELY installed the wrong prop on the quadrant that didn’t have left ( # 3 )
So, to be clear , I have THREE of 1 type of prop,
and ONE of the 2nd type ( where cross props are not same but opposite ) AND IT FLEW !
So, some of my questions are:
Do I go ahead and reverse the wires, or leave it like this as an ad hoc solution?
My concern is if it has opposite blades on motor than intended, the screws might work themselves loose and the props might come off and the drone might fall…
Secondly, I got an error message that I had never got before.
And when done the motor sat there beeping and twitching.