Recent content by Adamisprimal

*update* litchi no longer works on my p20 Pro and I by accident let someone use my Drone and they switched it to ce by accident. I downloaded RAINBOW pro apk and used the fake GPS app together to get my Drone back into FCC. If you need any guidance or anything like that feel free to reach out to me.

I just used this method on my Mavic air (huawei p20 pro fur phone)

If I am not mistaken they are the same props. But yeah did not get time today to do a hover of both of them to get a control to work with. Sure will do it some time tomorrow. I really appreciate the support given here gents. Wish I could do a tug of war with the 2 of them to see what Drone is...

I do think that I had my 2 spares on then only switched 2 from the other drone so not exactly all the same props. I have since then used the same props on both drones.

Think these are from both of the drones. So many files to sort through. Rate later today I will do a controlled test with them both and we can then have a looksee

I only have the 1 set and 1 spare of each. I took the props off off the 1 and put them on the other Drone in the exact same positions.

Same props is the same configuration. Lemme get some logs for you all.

So I appear to have angered some folks here. Let me start off by saying I am licensed. I am a Drone pilot and have 2000+ logged hours as well as being a level 3 RMT. I had used the lift test merely to establish if the flight characteristics I experienced were in fact real or just a figment of...

So I have 2 ma1's. While flying them yesterday I noticed 1 Drone is significantly slower. After noticing I switched the batteries around and still the 1 Drone was slower. I then did a test by lifting a 2l bottle with some water in and the 1 lifted about 80g more than the other. I then swapped...

So I am not sure what the fault is to be honest. I just tried to test it and the cpu fan started up normally. Took it for a flight and all seemed OK. Swapped batteries and then the cpu again stopped spinning. Put tgr other battery back in and it didn't spin it now either. Maybe I should try...

Meant the fan

So I have a mavic air and during a flight it reported that the CPU had overheated and it needed to land so I did that landed and upon inspection I noticed that the phone for the CPU was not spinning at all I tried to move a gently with my fingers and it had no resistance so nothing was bro block...

Yeah I know this, I was just wondering if you could upgrade the sensor on a Mavic pro to increase aperture or megapixels or even sensor size.

I was referring to the sensor in the camera, not the obstacle avoiding cameras.

So I was working on my Mavic air and my mavic Pro and was wondering if it is not tall possible to install a higher quality or newer sensor in the Mavic Pro as to improve camera quality. Rate I will see if the Mavic air sensor has the same connector as the Mavic Pro and go from there.