Update: installed the second new gimbal control board as well as two new sensors, and the front left sensor still isn’t appearing in calibration. I’ve updated all firmware and what not. So the issue must be stemming from deeper in the drone. I think I’ve officially given up. Too expensive...
And if what you are calling board B is the main board, (the bigger ones), I honestly Have no idea. I suspect they may be the issue as well but I have No idea how to test it. Replacing wouldn’t be worth it, definitely due to the need to resolder everything.
I’m leaning towards it NOT being one...
If you look at the bottom of the connections on the ribbon cables for both the left and right sensors, there are markings to show orientation. The are identical. It was worth the risk lol. And I havent yet, since the ribbon cable on the right sensor was torn. But the right sensor was working...
That sucks!
Yea, I meant to try the last board I ordered Sooner so I could send it back if it didn’t fix the problem.
Life got in the way and now I’m down another $100 lol.
I’ll send this one back if it doesn’t fix it.
It’s hard to believe it could be two boards with the same bad left port, but I guess we will see tomorrow with the third one arrives. If that doesn’t fix it I may tear into it deeper, or throw it into the highway. Not sure yet.
I apologize for this being so long winded.
So I have dug and dug and I can only find a thread of one other having this same issue, and there was never a resolution.
I received the drone in pieces for free to see if I could rebuild it. I replaced all 4 arms, the chassis, the gimbal arm, and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.