BenThe's latest activity
-
BBenThe reacted to motocatfish's post in the thread Best position to attach strobe light on Air 3S with
Like.
I have my top strobe where it is shown in your photo. Everything works fine. I have a bottom strobe just behind the gimbal, so I can see the drone at night. When I point the gimbal straight down to see my landings, the camera gets the bright... -
BBenThe reacted to MS Coast's post in the thread Best position to attach strobe light on Air 3S with Like.
There are no worries about weight and balance issues with a strobe on that drone. The weight is insignificant and the intelligent independent speed control of the four motors precludes any balance issues. I've attached strobes with Velcro at the...
-
BHello folks, I just purchased a small strobe light to attach onto my Air 3S, so I am looking to find the ideal position on where I could attach the strobe light module. The module itself is small, about 40mm x 30 mm x 15 mm. The ideal position...
-
BBenThe reacted to Cafguy's post in the thread In-flight component temperature check - is this available in the Air 3S? with Like.
That's normal. The Motors will get hot enough to burn your fingers at times (hence the warning) BUT not hot enough to melt plastic. The Motor would quit before it got that hot.
-
BBenThe replied to the thread In-flight component temperature check - is this available in the Air 3S?.It is not Tiktok, I mean short videos. I can see the motor assembly physically detaching in the slow motion causing the crash, pretty hard to fake.