Recent content by Blithe74

Thank You very much. In my my opinion the sound with Anafi props worse then with original props.

It is a pity, it is a very pity. I was very much hoping for an increase in flight time. In addition, Anafi blades are less susceptible to deformation. Thank you for the experiment. Tell me how has the noise level and frequency changed?

It seems to me that for native rays, engines and propellers Mavic Mini the batteries you use are too heavy. Aren 't you afraid that engines could damaged or rays or propellers break? Or do you use other engines and propellers?

2. Anafi have diameter 1.8mm, Mini have diameter 1.6mm. Is the step of the screws thread at Anafi and Mini the same? 3.You install motors from Anafi to DJI Mini? Anafi motors have a different height and diameter if compare they with Mini motors? What is the result of this replacement?

Hi! The DJI Mini has very soft propellers and it came to my mind the thought of replacing them with propellers from Parrot Anafi. In one of your photos I saw propellers similar to Parrot Anafi. Everything is right? If this is true, answer a few questions: 1) What is the flight time on Anafi...

How I was think 746 is analog of 748 by logical scheme and pins. The amplifier do not have adjust of power. Amplifier will add some power (+18...+20dBm) for signal from AR1021X. I think only software unlock.

Hi Guru! Help please, tell me what the parameters responsible for the maximum speed and the maximum angle of inclination of the drone when moving forward, and the maximum descent speed in sports mode?

If "BMS died" still relevant. Some videos: where man restore battery form Mavic AIR. May be help to You with Mini, may be no...

Thank You for photo. Very strange, why Skyworks | Home does not know about 746 chips... And how to find datasheet for it?

You are absolutely right. Without analyse a circuit, put 0 or VCC to the work PIN, it can damage chip. May be need remove any resistor or drop any wire, but need analyse the circuit before.

I asked on another cites, but without results. I bad speak Englis, may be it's reason. If it possible, please, ask They about datasheet.

Need documentation for AR1021X-CL3D for understand, how made output power control.

You are right. VDET is output Pin, for feedback (I very bad know English). In this time to deceive AR1021X we can decreased signal from VDET. But question, what will be with signal in FCC mode?

Do you think the Pin VDET is feedback? In this case, the amplifier has a strictly set gain factor, for example 10 times, and the output power depends on the level of the input signal. In My opinion, difficult, but I may be wrong. I thought the input signal level should be the same, but the...

I 've been thinking a lot about this conclusion. I couldn 't understand why I needed a Pin that showed the output transmit level, if I set the output level myself. After looking at the documentation for other amplifiers, I came to the conclusion that this output is used to set the output power...