Recent content by Calicassy

Yeah I get cost. Take alot of pics, take your time sit back and enjoy the experience. I still have my original m2p never crashed,knock on wood and not if but when I am prepared knowledge wise.

Ive repaired alot of the m2p and m2z drones. Sounds like fan on main board is not spinning. Surprised that mainboard is working. All errors indicate esc.that is where all wires are soldered to. No hard you replace.that is saying motors 1,2,3,4, have problem. Most likely esc. Esc runs about 60...

Ffirst off, the simple stuff,try another usb cord, and try installing assistant 2 again. But I would say you have a rear sensor going out. About 40 to 60 bucks. Not hard to replace.but I could be wrong.

If memory serves, I replaced battery when I got it then found out it is not for the m2p. It would not bind and then I got smart and plugged into computer and wallah it said for enterprise. So I'm just going to sell for what I paid.

Yes i did ,no problem figure 2 lbs from tulsa,ok 74116 assuming united states post office i guess. That should be enough for you to figure out. Shipping costs

I think this is what you are looking for. Will sell 75 plus shipping

I have replaced many.its not hard but you have to solder 6 wires per arm that's the hardest part. There are videos about arm replacement that will show you at least how to open drone.take your time and take pics before you start step by step. Good luck

You might try djioemparts.com. there is 1 item no Pic that might be your cable.worth a look

Thanks for Insite, but I forgot to say battery has only 20 cycles, and all checks fine cell,by cell, the only weird thing is that always on.

Have a battery, that went into night night land. Opened, bench powered her, tested, battery killered and bam. Got it working, but it is on when off. Put it on charger in discharge it starts without me turning on battery and light is not on. But I can do so. Also when drop into drone,the drone...

Welcome from tulsa

OK got it. Will the same work with T switch position.

Now will this work with rm500 controller as well

I would like to learn how to fly atti mode.downloaded the program