I have had the same problem. I am going to try this procedure. Has anyone tried using the side port instead of the USB port to connect the Epson to the controller.
Does anybody know if the controller or software caches button commands prior to the bird being connected to the controller. I alway power up the controller and app before powering up the bird. I noticed that I hit the RTH button, the gimbal control and the shutter button prior to launch. Still I...
OK folks at this time it looks like it is a bad controller. I switched controllers and cables and the problem seems to be related to the original controller. I will verify that as ASAP. I needed to do some work so I didn't want to have to post here that I tried a flight with a controller that...
OK what do I do with the file. The viewer doesn't open it. Is there another way to post it here? Never mind here it is.
I just did 2 or 3 very short flights with no problem. Then it happened again.
BTW I was very careful to not touch anything.
Sure. I launched by hitting launch icon on the DJI go app. It the asks for precise landing, which I also check then slide to the right to launch. Thats what I did.
Here is a new clue. I can not recalibrate the IMU. I keep getting an IMU2 failure time out -2 code
I'm going to recalibrate the IMU and compass and see if that helps. It happened using the DJI Go app and FT Aviator App so I'm thinking something is happening on the bird.
RTH has worked perfectly. It seems to be kicking in by itself. I press the launch button the home point is set and the bird lands, showing the message:
Aircraft close to home point "go home" shifts to "landing
I'll post logs asap
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.