Recent content by Dogpilot

Yes, it is available on eBay or Aliexpess.

Well the one I have does brightness, tilt, has flashers on the side that are controllable in flight and only cost $345

Look on the Mavic 3T thread, it has pics of several aftermarket models. There is no DJI spotlight for the M3T

I have been using the N3 SDK spotlight on the Mavic 3T. It has brightness controls and tracks the gimbal. It has its own software which automatically loads and shows its controls on the controller screen.

While it would work, you would need to find the old software to flash the firmware. Again, all this sold a year ago.

Leaving on a trip for about a month, so be off line. Pelican 1510 airline carry on for cameras and drones. Comes with the TrekPak divider system with extra dividers and pins and foam cushions. A wonderful case with lots of storage. Just have not been using it much lately. IN decent shape with...

Placing any of these over a known point is best. What they get on their own, without being connected to the NTRIP network, will vary a bit. In my personal experience, using the D-RTK-2 unit, placed over a known point with the highest level of survey accuracy (points all have differing levels of...

I agree the Emlid is a better choice. The D-RTK-2 has monkey simple workflow if total accuracy is not paramount. Emild requires a bit of practice and/or somebody to instruct you the first few times. Getting a NTRIP/CORS account is best, but some spots suffer from virtually no coverage. Kind of...

The accuracy is lower with the D-RTK-2 at any random location close to where you are working. Exactly how much depends on a whole lot of factors. If you place it on a known control point, it gets a lot better, down to 5 cm I believe. There are a lot of known control points, check out this...

That seems worth a try. There is a bit of an issue with the hotspot not being all it can be at times as well.

Actually, I do the surveys in smaller chunks to avoid the battery swap issue. There is no issue merging it all later in software. My big gripe is waiting for RTK to converge each time. Wish we could plug a power supply into the USB port while it takes its merry time to converge. Yesterday it...

Sold it all some time back. Sorry, should have updated this post.

Been a crazy winter here. I have been using the 3T, but during the day. I has been painfully cold at night, I even need to wear gloves to fly during the day.

I was doing some 3D work with the 3E and thought I would try it out with the 3T. Using RTK and connecting to the NTRIP/CORS network I let it collect a normal mapping run in visible light. While it will not correct up with time corrections for extreme precision, it does a perfectly acceptable...

Mavic 3 Classic in good physical shape. Throws up an error :Incompatible Gimbal Data. It needs to go to a service center to run the gimbal calibration routine. Comes with the RC-N1, charging cable, iPhone & USB-C phone connector cables, 32gb SD Micro card, full set of aftermarket blades with two...