Recent content by Herbie

Thanks

Just too make sure. Too initiate RTH you press/hold the button and to cancel it you just tap it?

Also would like to know as I once had the same warning. Thanks

Mine 5 months old, no problems

Makes sense thanks

Just asking but aint it a bit risky to put locktite on those small screws? I know locktite from the automotive world and in some cases you cant get a bolt lose without heat and a few meters of extension now what if that little starhead bolt strips?

What is payload mode, like extra power or motors are overloaded? Also when do you switch to payload mode?

As far as I know and have tried it, is that once it is about a foot above ground and it says landing nothing stops it descending

Very interesting thanks

I did a RTH under normal conditions and when it started to descend right above the landing spot I manually took it up, down, left, right etc and just before touchdown it also gave me unsuitable location on a rubbermat which it has landed many times before and I had to land it manually.

When in descend mode how far does it desend, 1.2m as in take off agl?

With signal failure you got the one option of descend. If this option is chosen how far is it going to descend?

Sorry yes the top one

I always before each flight twist each prop about 45° to give it more lift. Dont know if it works but never had any problems regarding decent or motors. On the prop pictures it looks as if the bottom one has negative lift at the tip. Regarding the prop folding into the case mine works 100%...

The first time it was on concrete and the second time on grass. Will check the next time, thank you