Recent content by HSK

Thanks for this, I'm going again next week. Will take the Mavic again. On the way in I keep it with me, on the way back it goes in the hold.

That's exactly what used to happen to mine. Couldn't fix it myself I'm afraid. I ended up returning it to the store and exchanging for a new one as I didn't not want to send back to DJI. Can you still return it?

Still say it again. It's an hardware issue. most likely the cable. I returned a Mavic that was doing that **** all the time, for a new one. The new one works fine, with same phone / settings / mem cards, where as the old one did NOT.

Well I got it before any file splits (within a minute even) On different cards. I think it's various types of issues, that manifest a similar results. That's why there's too much debate and nothing conclusive. I believe my issue was the cable being damaged in some way.

I've left it as it is. As it still has one clip it seems to hold. Can't be bothered to replace that whole bottom part of the shell just yet.

Yep. Of myself, and sometimes others. Pm me if you want samples.

Okay well, there you have it @Stivan. Don't upgrade if you want to go back people!

Sorry to break to you, you're stuck with 0100 for the foreseeable future. You may be able to downgrade to the other firmwares available in assistant, but I've not tried that.

If you can get to 2100m (with an unmodified antenna?) That's pretty good I'd say...not surprised the signal get lost after that.

What's the benefit of mixing modules? To make the app recognize the firmware to be updated / in order to use newer versions of Go?

It has been known to happen. Under various conditions and circumstances. And some resets are quick events (gimbal freaks out once) or longer, just like what you've shown... what's Interesting in your case, camera seems to have continued to record. Whenever it's happened to me in the past...

Think I may of uses it at the beginning to "test" the feature and see the accuracy of the landing spot. Then there has been one occasion where it has triggered after signal failure...drone was 50 meters away. So that was strange.

I still haven't been able to change firmwares using dumldore, it either fails, goes through and remains the same or does nothing. VM ware flashes work okay. I'm wondering if the pyduml method would work better...I just want the AC on .0700

It's unlocking the spark AFAIK, if it's been grounded by the mandatory firmware update.

Thing is with this issue, is that people seem to confuse it with a few other similar issues. Gimbal reset issue is not when your gimbal freaks out, and carries on recording, nor has it got anything to do with "file spilts". It's when the camera does some weird crap - usually pitches up and...