Thought the post you quoted was clear enough but i guess not. Have a think about it. Your on an older firmware, you upgrade. After your done you swap battries. Battery you put in was not in there when up upgraded, so it on an older firmware and triggers the message.
all i can suggest is downgrading twice to the same firmware. so say .300 and downgrade, it fails, then down grade to the same again.
does it always hang at 7%?
You can’t just flash in a single mixed file. It wont work correctly. If you open the file u will see a .cfg.sig file (ignore the garbage at the top). It will have a list of file name. Only those file names in the list will flash. If a file doesn’t exist it will be skipped or if its in the...
Yes that logs the flight control data as the card is ON the flight controller. The card isn't even populated on later firmware as its logged to the eMMC and as I said, you cannot upgrade the firmware like that. End of story
If you dont know, dont just reply
Anyway, you have two options. Send it...
Also you dont NEED to do the Anti-rollback (the latest one. Say NO to it. Your not rolling back). Your saying yes because its saying Stage 1 and 2. Dont do that
Sure you did it correctly? As it says "Media Disconnected" for a start (ie its unplugged) and also it says DHCP Enabled which means the IP you address you set hasnt saved. DHCP = Auto IP address from the device, Manual = hard set.
If you cannot go to ftp://192.168.42.2 with a browser or what...
Hmm you need to make sure you can actually talk to the FTP. Some newer Windows versions the whole IP address of the RC/Drone gets screwed up and isnt assigned by the the RNDIS driver (DHCP). The version stuff is sent over serial not network/ftp so that will shwo up if there is no FTP. Try doing...
The "Inconsistent Firmware" message can be something so simple as the battery wasnt updated (you threw in a different battery after you updated) and you just need to reflash. ie Battery is the old fw version and your AC is the new. Simple fix
First off. DUMLdore does EXACTLY what the DJI Assistant2 does, it just lets you load an older one which the Assistant 2 doesnt. Once the firmware is transferred to the Drone or RC (its via FTP mind you, that's all it is, and then a simple command to say "START") its ALL on the drone. You can...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.