Recent content by John Mac

Hex heads or Torx would be a great design improvement over Phillips. But you'd be on your own if something did not work out (like a prop flying off during flight) due to your design change to OEM. The OEM screws are manageable to remove and install with the correct size screwdriver (Philips 00...

In the US we have a 400 foot restriction above ground level per FAA. That is 121 m. There is a setting in the DJI App to alter this setting, up to something like 300m. I'm not aware it turns on Remote ID when you do so. It is a setting, I think under Safety. When you do so, you are prompted to...

I attempted to change out a set of props (nicked) just now, and the Phillips screwdriver sent with the Mini 4 Pro seemed improperly sized for the prop screws. I was just spinning in the screws and concerned I would damage the screws and be unable to remove them. Tried a different size Phillips...

Worked fine with a cable with USB-C for the RC2 end and HDMI for the monitor end when I tried it today.

So how does this drone show wizardry work? I can see how you could program the equivalent of waypoints for each drone's flight, and the waypoint flight of Drone A could be transposed by so many feet from the waypoint flight of Drone B. But I assume the drones have to report back their positions...

Anyone have any recommended sources for 3T's? They don't seem to be that common of an offering and I have not seen any in stock anywhere

Greetings all. I bought a drone out of curiosity recently, and I've been having fun flying a Mini 4 Pro around my property for the past two months. Lots of chances to fly and do video/photography just walking out the door where I live, as it's a rural area. John M.