Recent content by John32

Any perfectly leveled flat surface away from any magnetic field is what you need. Indoors or outdoors no problem. No more than 2-3 minutes time needed for calibration. Keep in mind to follow the instructions on screen of your device placing the drone exactly as it shows. Failure to follow the...

Hi the terminals are 10. (photo1) Looking the battery terminals count from left to right no 1 2 3 4 are positive, 2 midle are data, and the last 4 (left side) are the negative ones. Mine batteries are giving positive at no 2 3 4 and negative at 7 8 9 (???) Any way... So some guy made a copper...

look here...https://youtu.be/JXnp3PQiJ6s?t=2

It is your decision of what to do. But it is for sure problem to the locking mechanism. You just have to check it for a wire missconnection. Its a simple procedure if you want to do it. The only small difficulty is to separate the cover of the battery from the body cause of the double side...

There are gps based cards on the market that using a sim card so they are placed on the drone and when it crashed and lost you got latitude and longtitude data send in your phone so you can find it more easily. You can find these detection device in Amazon for less than 50 Euro..

Hi. Saying that the battery is charging normally on the dock, and getting just a warning that is not connected properly, my mind goes to a misconnection problem in latch communication. As you know when one or both of the latches are not completely been return to their position upon placing the...

First try a clear firmware instalation. Make it through WiFi connection with controller and mobile connected (not through assistant2). Take care of possible magnetic interference at the point you try to do any work. If it is still under warranty you can get a refubrished one. If no, and no...

Hi. What is the exact problem with IMU? Before do change it, try to calibrate the IMU in a completely level surface and in a completely clear of any magnetic field place.

See this flying distance in Greece.. 6Klm range....

WiFi sometimes can be affected even of atmosphere high static charge and in many places around the world of the sun's ray activity. But be sure.. you got to fly without problems within LOS or a little further, and that's the safest way to do it. Because sending your precious drone too far away...

The range of the air1 depends on WiFi interference. So after adjust the system to fcc (using fake GPS) always check the frequencies board for the amount of interference. Choose the clear line next to the lowest green one if available. In a clear of interference environment the air 1 can achieve...

Hi man.. Thanks for your good words. So best place to buy is a local store, just in case the new battery has some fault. In this way you always can return it. But anyway my personal preffer is amazon, gives a guarantee and a reliable transaction. Have in mind that if you follow the proper...

Hi. Air battery costs around 65-75 € and you can find them in Amazon, in eBay or in your local RC hobby store. In case you'll be interested rebuilding one you should find 3 LIFE battery elements 3.7v each. Instead you can open carefully the dead battery, remove the dead elements and keep the...

Before doing anything else, try to check the magnetic field level on the place you are flying. It is common cause of such behavior. Also check out the existence of wifi's Interference. Change from 2.4 Ghz to 5.8 Ghz and see If the problem still remains. If all are clear, take a look at IMU's...

Definitely it is not a matter of IMU problem. Doing this only in APAS seams that something makes the sensors think that some obstacle there is in the direction of flight and the system tries to avoid. If MA1 flies normally in other mods all works good. Please first try to clean all sensors and...