I came on here to research the same problem. At least now I know it's not just me. I went so far as to factory reset the controller but it's still showing as up to date but with the older firmware.
Guess I'll just wait and see.
Update to my situation posted above.
First off, let me explain that I had an issue where the drone would fly fine for a couple of minutes but then it would give error 30165 (stuck motor) and fall to the ground. I flew several short flights trying to figure out a solution.
Apparently when...
I'm in the same boat it appears. I crashed my M3P and used the care refresh express to get a replacement. It still took 8 days but they did give me what appeared to be a new drone so all was good.
Literally the first flight out of the box the replacement does fine for about two minutes just...
Are you getting any error codes? A brand new replacement did the same thing to me last week and I got 30165 (edited, previously wrong number) motor stuck. It was literally the first flight out of the box. Couldn't find anything wrong with the motors so sent it back to DJI., and they're...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.