Today i tried to swap the camera, the problem still there and maybe i knew what wrong! I used “bubble level” app to check my table surface for IMU and this is result
Do you think this is what cause my drifting problem, is it need to be exactly level? To be honest, the table top is the flatest...
Man, i dont know that i am so unlucky like that, i bought both of them with seperate propeller and controller and had the same problem! Do you mind show me short video about how straight you mavic are at 50metter high?
So you mean that i can calibrate near magnetic and if the surface flat but i am not sure about level, is that bad? And after factory reset, do i need to recalibrate IMU again
You mean factory reset the drone? And should we update to newest software again? Oh and how do
You think about my IMU calibrate environment? Is it bad to close to microwave and should i be either flat and level? I just cant find perfect place like that
Oh about the IMU, i dont have space so i just do it on table surface, with microwave 1m away from my drone, i am not sure if table level is good or not! But it the flatest thing in my room
Yes i did too! So the wind in the picture i show is high? And 50 metters is high too? Sorry because i dont have much exp flying these so i wonder a lot
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.