Recent content by makla

While I'm happy for you to be happy, I still think " wen cannot do a thing" is cowardish and plainfully wrong response. Their support told me that I should simply NOT select "care refresh" when I create the support ticket for sending the drone in. I did NOT select it and, thus, my care refresh...

This is very interesting, we should make sure to keep track of these incidents as the pattern is quite distinct and always the same (especially about not being to connect again without rebooting the drone). Sadly, I have no solution or explanation to that phenomenon, still, as DJI simply...

Interesting! So you simply got a new drone, not a repaired one? Did you "use up" your refresh care for that or did you have to pay for that? Cause I think this would not be correct as they clearly found the problem on DJI's side in my case. But it's great to see that we are now both happy with...

Just to keep you in the loop: I just got a mail from DJI support, telling me that they will replace both "Remote Controller Main Board" and "Aircraft Core Board Module" for free. Sadly i do not know any particular problem they might have found. It sounds to me add if they could reproduce the...

Wow, then it seems to be hard to reproduce this error. But it's great to see that it seems to only happen once per unit^^" maybe some kind of unintended initialisation

Thanks for your reply! :) Did you, by any chance, upgrade your firmware right before the problem occurred for the first time?

As the first thing I did after unpacking was to "install firmware upgrade", I would maybe add the current new firmware on my watchlist for being at fault. All posts about similar problems seem fairly recent (but of course the mini3 itself is not very old yet, too). Very interesting, thank...

Thanks, I, too, do hope that DJI will find a fault on the drone instead of simply returning it to me unchanged. Trust is a somewhat important ressource with drones :) . I've had 2 years with my Mini 1 and I did NEVER have any problem (except weak signal for 1-2 seconds). Nonetheless, my post...

Thank you for your reply :) But yes, i did try restarting the RC. Several times, actually, as i had plenty of time to try reconnecting my RC to the drone. Not even after i held the crashed (yet functional) drone in my one hand and the RC in the other. But mere seconds later, after...

Greetings everyone :) I'll be honest, I'll copy&paste my description and the attachements as I've tried multiple connections points so far: By now, after lots of further reading, I do gain the feeling that there might be more problems like this, but other circumstances make it look like...