Recent content by Mavic752198

Don't think it's based on usage. My 2+ old Mini 2 had maybe 15 flights on it. Took it out today and the front right motor is sticky/stiff. It's basically been sitting its whole life. Something else going on with these M2's. Anyway it's going back to DJI for repair (out of warranty)

They finally replied after several follow up emails asking for order cancellation. They confirmed cancellation. A few days later I asked them when I could expect a refund. No response. Two more emails over the next few days asking about the refund. No reply. I know they are a sponsor here...

DJI replacing your gimbal or your whole Mavic?

awesome, just ordered one Thumbswayup

ok, good to know, thank you. I need to find some thin felt stickers to line that part of the gimbal guard then.

Purchased new from an eBay store. Box says 12/2019 That‘s the only date on the box.

Also, although I don’t think the M2P I purchased was used I did notice this after removing the weird gimbal cover. I’m not sure if this is a common thing maybe someone can chime in but the top of the gimbal was scuffed up pretty bad. I figured the gimbal cover caused it but who knows.

Let me know if you think this is defective. I have seen other brand new gimbals being off here in the forums but mine takes the cake. This M2P is going back to DJI hopefully for repair and not a used M2P replacement. Each of these pics are facing a direction. East is the worst by far with...

Find it hard to believe the Mavic batteries aren’t wired from DJI’s BMS with balance leads. The Phantom 3 batteries are. The BMS takes raw power from the charger then manages all aspects of charging including balancing towards the end of the charge cycle. Again this is how it was on the P3...

I would have thought that DJI had figured this out by now. Coming from the Phantom 3 line I know this was very common but I didn’t expect this new M2P would have the issue. My very first flight went straight up to check this a lo and behold crooked. Even before the first flight I did an IMU...

Brand new SC today, updated fine for me from the controller.

That SoC, the Rockchip RK3066, had a release date of: Announcement Date 04/01/2012 https://www.notebookcheck.net/Rockchip-RK3066-ARM-SoC.86864.0.html Also note the SoC is 32 bit which means the GO 4 App that runs on it is 32 bit. A lot of ppl are upset that DJI didn’t release a 32 bit...

Just got one of these today. Install the Amazon App Store. Then download the CPU-Z app. Some interesting nuggets: Rockchip RK3066 SoC @ 408 MHz - 1.42 GHz 6 Cores GPU Mali-T860 Android version 7.1.2 (very old but most concerning is Android security patch level is ancient) 400 dpi Screen...

Any way to get rid of the obnoxious ”Enhanced Warning Zone” and “Warming Zones” colored circles? This can be done when flying the Mavic Mini with the DJI Fly app. It seems this cannot be done when flying the Mavic 2 Pro with the DJI Go 4 app. The 2 zones mentioned are not “Authorization...

Same here. Brand new SC.