Recent content by mgracio

Im waiting on a yaw motor myself ^^ Good luck!

Hello. You should have movement in all axis using those calibrating functions, and from what I can tell, only the pitch motor is working. there might be something wrong with the roll and yaw motors or cables. Good luck, regards!

Hello. Im not 100% sure, but it would seem to me that the pitch motor is not going though its whole range of motion. Also, you probably tried this, but there are two operations you need to do, I can only make out one of them in your upper screen. py comm_og_service_tool.py YOUR_COMM_PORT -vv...

Thank you for the video!

Thank you very much!

Oh for sure to replace would be easier, but not half as fun! If not, could I trouble you to ask the builders you know if missing the yaw motor negates all gimbal operation? My belief is that the firmware tests for it, if its not there it assumes the gimbal is ripped off and doesnt even try to...

Hello and thank you for replying! I maybe phrased it wrong (english is not my first language), but I did disassemble the gimbal and passed the camera (gimbal control?) cable through all of it, what a pita that was -_-!! Here is a picture of the completed work, Ive already removed the yaw motor...

Hello and thank you for replying! How much are you willing to spend on your repair? - As little as possible ^^; As of now the bill is like this: 6.8 Eur Rear axis 22.4 Eur Front sensors 11.5 Eur Gimble camera cable 40.7 Eur Total A gimbal yaw motor will be another 25 Eur, for a total of 67...

Hello all. I recently got offered a mavic 2 drone which was involved in a crash and Im trying to get it working again. In addition the other damage, the camera cable connector was ripped out and the yaw gimbal motor flat cable was cut clean off. I have installed a new camera cable and was real...

Hi. I believe that would be a 40 pin on flex/motherboard connector Cheers.