Recent content by Moss99

Just add some leaded solder at the same time , I’ve just replaced all 4 arms .. 450 degrees is all I needed

What does it say when you try to calibrate vision sensors with DJI assistant ?

I see , its all pointing to the esc then . its very interesting all this stored data .. is all the extra info buried in the code and hard to get ?

Wouldn't the current drop to zero if the the motor was physically stopped, hitting something maybe , that would account for the motor obstruction message .

I will change esc board too then to be safe ..

i have done some tests with the motor measuring the ac output volts when spinning it , they are the same across all phase , also same when compared to a good motor , . i also checked the resistance with a milliohm meter the windings seemed ok . Would the esc shut down the motor if it got too...

my mistake ,, it was the rear left motor which felt tight , (the one that failed )

I cant see where you add location on the profile page ?

cornwall / UK .

Thanks for that , great info there , is that using CsvView programme ? , as i mentioned in one of the above posts one motor did feel a bit tight and it was the rear right .

can this tell if the motor stopped getting power or jammed ?

Hi , ok , i have finally worked out how to extract and view the log ,correct me if i'm wrong but it looks to me as if the back left motor stopped working . Dropbox - FLY157.DAT

I have the .DAT files , but i have run out of time now and will post them after work this evening .

Hi there , I have been looking at that , i plugged the mavic pro into my pc and with dji assistant , i have the black box files on my pc , not sure how to view them though

Or maybe GPS / compass disconnected linked to bad battery ?