Recent content by muddblood

Replaced downward vision sensor board and all error messages are now gone. Had a nice flight today, used the return to home feature (because I lost visual with the aircraft) and it had a nice soft landing.

Performed a 2nd sensor calibration and same issue. I hoped this would resolve the issue as I did the initial calibration with that ribbon cable unplugged, but no luck. Tested drone again powered on and DJI Go4 open and connected and bottom sensors will not read anything less than 5’. Top sensors...

Hello gurus! I just finished repairing my 2nd hand Mavic 2 Pro (replaced left rear and right front arms) and it flies great and everything seems to work, but I’m getting these error messages: “Infrared sensor error” and “Hardware malfunction”. No specific error code numbers. When I put the...

Bummer! The guy I used really just used dronehacks software to update the firmware and I believe got a firmware file from the link provided in the software. There are YouTube videos on this, but a lot of the info is blanked out so they can charge you money to remote in and fix it. I’m not real...

Might be a Win11 thing, but your commands look very different. I used these exact two on Win10 and they both worked. Obviously COM3 and WM would be changed for your individual situation. py comm_og_service_tool.py --port COM3 WM231 GimbalCalib JointCoarse py comm_og_service_tool.py --port...

Did you change the device name as seen in the first post? Can you post the commands you used?

For those that are having this issue, try these commands. Worked with my Win10 laptop, Python 3.11.8, Mavic air2. COM needs to be all capital letters. py comm_og_service_tool.py --port COM3 WM231 GimbalCalib JointCoarse py comm_og_service_tool.py --port COM3 WM231 GimbalCalib LinearHall