Recent content by nguyenmihung

I have used DH DroneHacks 😁

Change DJI NEO parameter Every time I fly in and out with N or S mode, DJI NEO tends to increase the altitude a little bit, which is very annoying. Because the default altitude that DJI presets is the position that the sensor can get most accurately, when reaching that altitude, NEO will keep...

I have successfully unlocked the battery circuit for DJI MAVIC Air, you can use lipo battery cells or batteries with 3s 4s voltage as in the video above. If you want to refer to it, find me, share it for free for everyone to use.

I think it would not be good to turn off the sensor completely in ATTI mode, because I only want to disable the GPS signal. ATTI mode is like FPV quad (no acrobatics), it drifts and there is no sensor to hold position limited to 30ft. OPTI mode is very suitable, I think wrapping the GPS antenna...

Thanks for your answer. I am looking for a faster solution. If possible, I will try.

Can you guide me to turn it off? I don't know where to enable that ATTI mode in DJI Assistant.

Thanks for your answer. I'm thinking about this, a low flying FPV drone, but an FPV drone can be a lot more expensive than the one my mavic air is using, takes quite a bit of time. time. time. time. practice time. much to get used to aiming and controlling. I would like to ask if it is possible...

This information is very helpful, but I think it is possible to disable the built-in gps in the mavic air. Maybe the manufacturer has hidden it. The Mavic Air is quite perfect for flying in a full GPS environment. As for the flickering GPS, it seems a bit annoying to me. Location "Home Point" is...

I have a Mavic Air 1 drone, it's cool and has lots of fancy functions. But there is one problem I'm a bit worried about is that I can't turn off the GPS. Is there any solution to disable GPS of DJI Mavic Air 1 drone using DJI Assistant software or just hardware intervention? Because in the...

Thanks, I edited.

I think I should open a small adjustment in Dji Assistant on the computer, reduce the "landing" voltage from 3.0v to 2.5v.

Hãy chia sẻ nó nếu bạn có thể.

Please share it if you can.