Recent content by Pharaoh

Here's my page. Pics shot with Mavic Air and Canon 6D: Arto Isotalo (@isotalophoto) • Instagram photos and videos

I have tried it a couple of times too, it seems to work really well. Much nicer footage than manually controlled. At least with my piloting skills. And, it seems to keep the FCC mode on :)

Thanks! These are easy and soft to put on, and they don't scratch the drone. I use them quite often, especially on dusty and grassy surfaces.

Sure, here you go. I found the smallest dots don't stick that well, at least with the material I used.

No, they don't block RF signals.

Thanks! It’s my own design. Cut with a vinyl cutter.

Normal PLA won’t work, these need to be printed with a flexible material. They are pressed onto the legs. I used Verbatim Primalloy (TPE). Flexible PLA could work. Yes, they are meant to be flown with.

The Air's legs are quite difficult to measure with a caliper. There's no symmetry and the faces are all tilted in different angles. I did a few iteration prints too before arriving to the final version.

Thanks! No, these need to be printed with a flexible material. They are pressed onto the legs. I used Verbatim Primalloy (TPE). Flexible PLA could work.

[emoji4][emoji106]

Thanks! Did you design leg extensions also?

Thanks!

Hi! I've been just reading the forum posts so far, this is my first post. I designed leg extensions for the Air. You can download the stl's from here, if you want to print your own: DJI Mavic Air leg extensions @ Pinshape