I am in the UK. Aircraft is firmware 01.00.0310, RC Firmware is 02.00.500. When there is no GPS signal it is maxed out at 500. If there is a signal it can only fly 120m irrespective of whether the slider said 500 or not.
There is another thread that describes the same with the mini 2.
I know you do not intend to but did you try going past 120. Recently I noticed that I can set the slider to above 120m but when I try to pass 120m
You can change to a higher number but if you try to fly above 120m it limits your height to 120m.
Thank you very much for the clarification that in theory it will be the case. I will give feedback once I have travelled and confirmed. Thanks once again.
If I am in my house and the controller/drone have not connected to satellites I can set it to 500m but can't obviously fly. Once I go outside where a satellite signal can be received, I cannot set it to above 120m (400 ft.) using the slider. If I fly to 120m a message appears saying I have hit...
When the controller and drone have just started up I can select 500m. I think that once the drone connects to the satellites and determines it's location the maximum that can be set is 120m. That's in the UK. While flying I could not go past this level. Maybe 125m, but that was it.
Hi. I purchased a DJI Mini Pro 4 this week. It is limited to 120m flight height. I am in the UK. If I were to take this drone overseas, not in the EU where these regulations do not apply, would I be able to fly to 500m? Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.