Recent content by pitchmagic

Updated Mavic via Assistant and that went well, tried to connect the RC and it wasnt recognized.. Connected my Iphone to the controller and turned everything on - inconsistency in fw/upgrade. Did that via Ios and all was good. Did a quick testflight and all was good!

Will we finally see a change in the hot fresh .500 FW? *holding my thumbs*

New FW out! Update now! :)

New FW out!! Will that deal with this problem or not? There is also an updated GO app. Its not showing in appstore yet though.

Do you have the new firmware?

Do mavic first, cable from mavic to pc. Turn on mavic, start dji assistant 2(log in to assistant) then do the downgrade. When done, do the same with the controller! Good Luck Have Fun! :)

Hi, use the short cable that came with the mavic. Do the mavic first and downgrade/upgrade then the controller. Do not forget to restart both! GLHF!

Try updating with DJI Assistant 2 instead from PC/MAC, both the Mavic and the controller, one at a time.

Ok, that twisting made a difference - no more errors and when reading the log p2p is down to about 50 - on full speed!! Thats an impressive difference.. Comparing from the old value that was p2p 257 its about an 80% difference?

That antenna wire is shielded so It should not be affected. However, people have noted disturbance in the range and all wires that handle current should be shielded/twisted. That problem might not be relevant but better to supress as much noise as possible.

You need the high+low value at the same given time. The pic dont tell that. Only look on back or front. My back fluctuated 257 p2p at the worst.

I asked the same a few posts up! :)

It is possible to remove the torx on the arm(not the one on the body) and pull out. However the cables are short and you might damage the cables. Because of this I did the full monty and opened the top cover. The hardest part was opening the front clips. Gahh. It worked though. I removed the...

Just out of curiosity, how did you update? If you used a cable - did you use the short one supplied?

Thanks, I will do this today!