Should spin freely by hand. Probably some dust or debris. You could try to blow it out with compressor or just other source of air. Also check interference between motor and leg. If nothing helps. Could be motor bearing problem. Motor should be replaced in this case.
By the way. To address gimbal issue in normal mode DJI seems reducing max speed when camera set strict down. It could leads that in strong wind drone starts drift. Without wind warning. Or you unable flight as fast as you expect. So use camera down view with caution. And be aware why drone could...
That a bit strange. But from my experience, to have good video on Youtube (even if need 1080) you should upload it in 4k. I always have like terrible results when upload 1080 video. But 4 k looks nice in both YouTube resolutions 4k and 1080
Do not know what they are doing wit 1080 source to make...
Yes. VLOS and etc. I know.
But that very important skill to be able positioning your drone using map, on screen compass and visual orienteers from camera. You need to train it. To do not panic, bring it closer and get visual contact.
Guys. Really.
Having almost 400 g controller twice bigger in size and weight then sub 250 g Mini 2 is stupid move. Seems like anectodical. when I place it side by side. For me and many users who chosen Mini for compact setup was really upset seen that. And only one reason why DJI made that -...
Was also worry before start flying. But DJI Mini 2 so small and quiet. Few times took off in park but just choosing not very congested place. (It is allowed in my region. If not too close to people and that not special regulated zone.) People around does not care or just assuming that is a...
After I've updated dji fly to 1.2.2 and updated firmware, quick transfer stopped working for me. Mini 2 switched to quick transfer ok. DJi fly prompted to connect drone, but then failed to connect . All was working fine before updates. Does anybody faced same? What could I do to fix issue? Not...
Does not really matter. But I usually start drone first. Because it can take some time to get good GPS fix. Then after I start RC and application drone usually ready to fly. If I start drone after RC I usually need to wait GPS fix .
Have same on Mini 2. Back to normal only after DJI Fly (Android) kill and restart. DJI Support asked for logs from DJI Fly an other data. I advice all with the issue contact support and provide data they ask. That should help to fix bug faster.
Didn't you check gimbal mode not FPV. I had near same issue with mini 1 when unintentionally switched FPV mode on. It was working strange when I slide aside. Like on video. Tilt from time to time.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.