Recent content by recoil

Thank you, I appreciate it. R. I. P. Beanbubba.

Well this is making me sad and although I just knew him from his post here it hurts that he departed. He did so much for this hobby I will always remember him. I came around to the board always looking forward to reading his posts where he push it to the limit, always got a laugh when I saw him...

? this is ominous, could you please elaborate? I hope he is ok.

Thank you Exphantomflyer, I think is time to send it to DJI.

The camera controller is ok since as I mentioned before is part of the entire assembly that I moved from a working AC, Thank you for the info any other ideas of what to check?

I recently had a crash with my mavic, the camera stopped working and gimbal was shaking violently. I got another whole camera assembly (gimbal\camera\controller card\shake board) that I know is good (it came out of a working Mavic) and tried it in the damaged Mavic, the gimbal worked fine no...

For that you use something like this ... 3S 20A 12.6V Cell 18650Li-ion Lithium Battery Charging BMS Protection PCB Board_ 973777475251 | eBay

Hi Bean, it is just and indicator board that tells you how much juice you got in the tank. There is different boards depending on what kind of battery you are going to use, I was going to add a case to my antenna for the amps and battery, I was looking at these ... 10PCS Battery Capacity...

Thanks pal :)

Hi once more Beanbubba, my jaw dropped when I got your reply. I believe what you say 100% I just haven't been able to try it since I have not had flying conditions. If the man that is in it's 9th Mavic from testing the hobby to its limits says it works I am with you! Anyhow I know it seems clear...

Hi Beanbubba, let me see if I am getting this correct since I fly my Mavic with amps in both sides of my RC with circular antennas, I can take off the right side amp and performance will be about the same? Is that correct? Thanks!

Is the inside if this batteries wet? Or is it just layers rolled? Has anyone tried to remove the metal from them and replace it with shrink wrap tubing or something like that? Perhaps a dumb idea.

I repaired my Mavic Pro with a ESC platinum board, after the repair with the latest firmware DJI assistant recognizes the AC as a Mavic Platinum all is good if you want to stay with the latest FW. I was able to downgrade to 1.03.0700- (without adding the SD card to the ESC) notice the "-", since...

Thanks man :) I'll hold until the experts have a better understanding of the battery Talking about batteries, I am sure you guys have seen this aftermarket batteries For DJI Mavic Pro/Platinum/Alpine Intelligent Flight LiPo Battery 11.4V 3830mAh | eBay The one thing I am not following is that...

Thank you again CyberNate, let me see if I am following you. Take out the original cells and replace it with a 4s battery and connect only 3 cells, you mean connect all 4 but only connect the balancing leads of 3 cells? If so do you have any recommendations for a 4s battery? Lolo: if you are out...